Appliances and furniture
Overlay of concealed cabinet hinges — choose the hinge before sizing the door
You cannot size a cabinet door until the hinge is chosen: the overlay goes straight into the width, and full overlay versus inset differs by 18mm per door
This drawing comes from one YAML file. No shape was moved by hand.
Notes in the source (in Japanese)
扉の幅は、丁番を決めてからでないと出せない。 かぶせ量がそのまま寸法に入る。
側板 1 枚を、左右の扉で分け合う。18 ＋ 0（全かぶせ ＋ インセット）か、9 ＋ 9（半かぶせ 2 枚）か。中央の仕切りに 2 枚つくなら半かぶせが定番 ——片方を全かぶせにすると、もう片方が側板に載れない。
本体の外幅 800・側板 18・扉どうしの隙間 3 なら、全かぶせ 2 枚で 398.5mm、インセット 2 枚で 380.5mm。扉 1 枚で 18mm 違い、見た目も納まりも別物になる。
カップは 35mm、掘り込みは 12mm 前後。 厚み 18mm の扉なら残るのは 6mm で、深すぎると表へ抜ける（専用のビットがあるのは、深さを止めるため）。
付けてから左右・前後・上下の 3 方向に動かせる。木は動くので、作ったあとに合わせられることが、この金物の値打ち。
Source (YAML)
examples/gallery/260-スライド丁番のかぶせ量.zumen.yaml
More in this field
Fitting a refrigerator: clearances differ by model, and a corner turns on the diagonal
A bench built for making: tenons mitred where they meet, and a top that is never screwed down
A chair drawn for making: four tenons meet in the back leg, and they must be set at different heights
A fridge does not make cold, it pumps heat out — and it throws away more than it took, because the compressor's electricity comes out as heat too
Heating and cooling swap the roles of the indoor and outdoor coils, and the only part that changes is one valve — which is also why a heat pump briefly runs cooling in the middle of heating, to melt its own frost
Hot and cold spots sit 6.1cm apart because that is half of the 12.2cm wavelength, which no cabinet design can remove — so the food is moved instead
A shelf sags with the cube of its span, so doubling the span sags it eight times — and gluing a 40mm rail under the front edge does more than upgrading the board
The same drum has to stay under 1G to wash and reach 335G to spin, which is why it hangs on springs behind a concrete weight rather than being bolted to the machine